Descriptions：
|
Specification:
* Rating: DC 12V 8A
* Digital LED display to show Volts status.
* LED indicators to illustrate the charging process
* 2 way vehicle setting switch
-Safe charging of vehicles up to 2.7L
-Accelerated safe charging of vehicles up to 1.9L
* Start dead cars in 15-25 minutes
* Designed for 12V vehicles only
* Cable length: 18 feet
* Max vehicle size: 2.7L
* Replaceable fuse: 10Amp
* Size: 100 x 110 x 68 mm
* Weight: 0.58 kg
Operation Instructions:
* Make sure the lamps, stereo, air condition and all possible power using equipment are powered off.
* Select the correct setting on the 2 way setting switch
-Up to 1.9 L
-Up to 2.7 L
* Connect the plug with shorter power cord to dead vehicle, and connect the plug with longer power cord to normal vehicle. Turn the key of dead car to ON position
* Start the engine of normal vehicle, then the red LED turns on.
* After the green LED turns on, start the engine of dead vehicle.
* If you are unable to ignite the engine on dead vehicle, remove the plug with longer power cord and check the voltage reading shown on the digital LED display. If the voltage reading is less than 12V, you will have to charge the “run-down” battery again.
* Once the engine on the vehicle with the “run- down” battery starts, remove the plugs from the cigarette lighter sockets on both vehicles and stow DC-to DC charger for future use.
* Allow the engine on the just-start vehicle to warm up to operating temperature before driving.
|
